logo

T slot corner


t slot corner

Scaleauto braid may be soldered into the brass connector to prevent falling out during racing. .
Its well worth seeking out a specialist tool supplier for the cutter(s) - DIY superstores tend to have a limited range of light duty cutters - there are very good prices available from some of the mail order tool companies.
Reed is still a TE1 for Fantasy GMs.
Straying into metric profiles is perfectly fine; however, you should be aware that some accessories that you may have had your heart set on at the onset may not be available.#To bring the chassis to the correct wheelbase its allowed to cut the front sub-frame center section carbon SC402a to get the correct length.If due to a crash clearance becomes lower the car must be repaired before re-entering the race.No independent front axle set up, however created are allowed.All four wheels must be fitted with the correct Scaleauto wheel inserts.
You might think that having the top surface of the braid exactly flush with the track surface is a good ides, I've tried this and now think it was a good idea at the time but with the benefit of hindsight it was a mistake.
Davis is eligible to play in Week 11 against the Seattle Seahawks.




The recess for the braid should.3-0.5mm (10-20 thou ) thicker than the braid.#All chassis related parts need to be in a standard condition.Upon post race Technical Inspection any car found with non stock parts will be excluded from the results.Bouye (calf) said he will not be able to play in the Week 10 game because of his calf injury.Also the side mounts where the body attaches to the chassis.Routers, the professional track builders use high power routers which can cut the slot in one, or at most two cuts.Link to story Seahawks Doug Baldwin limited Wednesday Wed Nov 7, 08:47 PM Seattle Seahawks WR Doug Baldwin (groin) was limited in practice Wednesday, Nov.
The new Scaleauto GT 3 Chassis cars amendments.
Now for the vital matter of deciding what pickup to use and cutting the slot.




Sitemap